Analytical Technology A15 Specifikace stáhnout pdf (Strana 34)

ATI A15/66 Residual Sulfite Monitor

O&M Manual

Rev-W (8/10)

The cleaning cycle may also be started manually when Auto mode is selected. To do this, press

the UP or DOWN key when the display reads “CLEAN CYCLE: WAITING” in the previous paragraph.

The display will change to “CLEAN C: START” and then press ENTER. The cleaning cycle will be

activated.

If Manual mode is selected, the cleaning cycle must be started by the operator. To do so, again

start at display D6 (see page 20). The display will indicate “MANUAL CLEAN”. Press the CAL key and

the display will change to “CLEAN C: WAITING”. Press the UP key once and the display will indicate

“CLEAN C: START”. Press ENTER and the cleaning cycle will be activated.

During the cleaning cycle, the display will be flashing messages indicating where it is in the cycle.

At the end of the cleaning cycle, and after the holding period is complete, the relay and 4-20 mA output

signal will be updated and the system will resume normal function. During the cleaning process, the

relays and output will be held at the values indicated just prior to activation of the cycle.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41

Žádné komentáře

Analytical Technology A15 Specifikace Strana 34